|
| |
 | 15ul Plastic Capillary (25 collectors) | Single-use plastic capillary is used to collect approximately 15ul blood drop that is then squeezed from plastic capillary onto any one panel test strips for CardioChek ST and CardioChek PA analyzers |
| |
PTS 15ul Plastic Capillary (25 collectors)
Instructions:
1. FILLING
DO NOT SQUEEZE FILLS AUTOMATICALLY
- Stick finger with lancet to obtain a drop of blood.
- Hold pipet up to the blood drop (see picture) and touch the pipet tip to
the blood drop.
- The blood will flow up to the line and stop. Keep filling until filled to
the line.
NOTE: If the pipet is not filled to the fill line, it will not dispense.
2. DISPENSING
To dispense the blood onto the test strip:
- Place the test strip so that the ribbed side is facing up. Line up the tip
of the blood-filled pipet with the white reaction circle on the ribbed side
of the test strip.
- Hold pipet above the white reaction circle and squeeze firmly to dispense
the entire drop of blood (see picture). Do not touch tip to test strip.
Note: If the drop will not dispense, place your finger over the air vent
while squeezing.
NOTE: The pipet may be helpful in collecting and dispensing blood. A pipet is
required when testing with multi-test strips. However, pipets are not required
to test with single result test strips.
- Use 40 ul capillary blood collectors with 3-panel test strips
- Use 30 ul capillary blood collectors with 2-panel test strips
- Use 15 ul capillary blood collectors with single-panel test strips
Click
here for lancets, capillaries, and controls.
* Same
day and next day shipments are normally the case with the exception of any
out-of-stock items.
** Lifetime
member discounts are subject to member
terms & conditions. Also, use of this site & products sales that
result from this site are subject to our company's
policies & disclaimers
