AlcoMate Plus Replacement Sensor Module

AlcoMate Plus Replacement Sensor Module

AlcoMate Plus Module used in a easy-to-use breathalyzer designed to be used by parents and drivers. It uses a semiconductor-oxide sensor that requires a mouthpiece.We offer FREE SHIPPING while others charge $6-20 ship fees in lieu of a low price.

Product Home Page Features & Benefits Symptoms & Conditions

Other Alcohol Use Tests

Test Medical Symptoms Home Page

$29.95/module

What is a "Pre-Calibrated Replaceable Alcohol Sensor Module"?
The AlcoMate Plus is one of the first breathalyzers to introduce pre-calibrated replaceable modules (patent-pending) to the market. One of the main problems with using breathalyzers in critical applications is that the alcohol sensor requires periodic re-calibration. Unfortunately, the re-calibration process requires that the breathalyzer be physically mailed or taken to a professional service center, at which point the device must be evaluated and proper steps must be taken for calibration with an expensive simulator system. The process is costly for both consumer and service center, and the delay of processing and shipping back-and-forth can be quite a loss. The Pre-Calibrated Replaceable Alcohol Sensor Module can eliminate the delays and complications of re-calibration by allowing you to simply "snap out" an old module and "snap in" a new module. This way, you can get back to reliable, accurate testing in a matter of seconds!

How do I install a Pre-Calibrated Alcohol Sensor Module?
For the AlcoMate Plus, please take the following steps to install a new sensor module

The AlcoMate Plus offers the latest in cutting-edge breath alcohol sensing technology as well as powerful and convenient features.

Special Features
Active Pressure Sensor
Deep-Lung Air Sampling
Cumulative Test Counter
Low Battery Indicator
Auto Power Off
"One-Way-Flow" Mouthpieces

Prepare your AlcoMate Plus. Make sure it is powered off.	Remove the battery cover.	Remove the batteries.
Using a screwdriver, remove both screws under the battery cover.	Using a screwdriver, remove both screws under the battery cover.	Pull the two tabs (to the left and right of the battery compartment) up from the device.
Pull the two tabs (to the left and right of the battery compartment) up from the device.	Lift up the entire back portion of the device.	Remove the back portion from the device.
Remove the circuit board (with sensor and breath tube attached).	Hold the breath tube where it is attached to the sensor module.	Remove the breath tube from the sensor module. It should lift easily.
Pull the sensor module up from the adapter slot. Be careful.	Prepare a new pre-calibrated sensor module.	Replace the new sensor module into the adapter slot.
Press firmly to make sure that the new sensor module is secured in place.	Re-attach the breath tube, as shown.	Replace the circuit board to its original position.
Snap the back portion of the device back on to the front, securely.	Use a screwdriver to remount the screws.	Replace the batteries.
Finally, replace the battery cover.	Ready for Testing!

Alcohol Sensor:	Semiconductor type alcohol sensor
Size:	116 mm x 59 mm x 27 mm
Body Material:	Plastic
Weight:	105 g including batteries
Battery:	Two 1.5V AA Alkaline (included)
Detection Range:	0.00% ~ 0.40% BAC
Lifetime Tests:	~3000 tests
Recalibration Need:	Not required* *(Sensor modules should be replaced approx. every 300 tests)
Breath Sampling Time:	~5 seconds
Users:	Law Enforcement, Professional Consumers
Warranty:	1 Year