|
To insure your satisfaction it is advisable but not mandatory to generate a
known dried semen sample and do a side by side test. This may also help you
interpret the results of your test.
MEN
When using CheckMate Infidelity timing is very important. If you suspect your female
partner of having sex with someone other than yourself, you must make certain
you have had NO sexual intercourse with her for at least 7days. Semen can be
detected even after showering for up to 72 hours or more so be sure your have
had no relations with her for specified time period. Failure to follow these
guidelines could possibly result in a false positive test result. Everyone's
situation is different but use common sense when using this product. CheckMate
Infidelity test only for the presence of semen not who it came from.
WOMEN
Timing is the most important factor for the proper use of this product. For
women using this test on a man you must consider things like masturbation and
personal habits and hygiene. CheckMate Infidelity is very easy to use. Just wait
until the "right" time to do the test. Everyone's situation is different but a
good example would be.... If he takes a shower, puts on clean clothes and
goes out with the boys every Friday night then Saturday morning would be a good
time to do the test.
PARENTS
Of course undergarments are the best place to test but only you will know when
is the "right" time. Everyone's situation is different. Just follow the easy
Instructions.
IMPORTANT
The two supplied kits are designed to perform several tests each. DO NOT
MIX BOTH TEST KITS TOGETHER AT THE SAME TIME. AFTER COMBINING THE LIQUID AND THE
POWER IT REMAINS USABLE FOR A 24hr. PERIOD AND SHOULD BE DISCARDED AFTER THIS
TIME.
WARNING
Avoid contact with skin and eyes. Wash thoroughly after using
this product. Use this product with adequate ventilation and keep away from
children. Harmful if swallowed inhaled or absorbed through the skin. If
swallowed, give victim large amounts of water an induce vomiting. However, never
give anything by mouth to a convulsing person. Then seek medical attention. If
product is inhaled, remove victim to fresh air and if not breathing, administer
artificial respiration. If breathing is difficult, administer oxygen. If you are
unsure what may have occurred, seek immediate medical attention. Because of the
nature of this product and the conditions and circumstances under which it may
possibly be used, the makers and distributors of this product assume no
responsibility whatsoever for actions or circumstance that may arise as the
result of using this product. Checkmate is a screening tool and test result are
not intended to be used as legal evidence in a court of law. By using this
product the user agrees to these terms and conditions.
|
|
Step One
If you can actually see the suspected stain use the supplied dropper
and remove a small amount of liquid from bottle #1 and wet the suspected
stain. This only takes 1-2 drops. If you can't see a stain but suspect
one may be present, simply wet the suspected area. Allow the liquid to
soak into the fabric. If you are doing a side-by-side test with a known
sample you should also place 1-2 drops on this stain now also. After the
liquid has soaked into the fabric being tested proceed to step two
immediately before the fabric has any chance to dry.
Step Two Using one of
the supplied blotting papers simply blot the entire wetted suspected
test area with the paper by pushing down gently in different places
until the paper is thought wetted. If semen is present this transfers it
from the material being testes to the blotting paper so let the paper
soak up the liquid. Now set the paper aside to dry. If you are doing a
side by side test with a known sample do the same as above on the known
semen sample but with a different piece of paper and set it aside to dry
also. YOU MUST MAKE SURE TO DO THIS AFTER.....Not before you do the
test. If you were doing the blotting part of the test on the known semen
sample first you could possibly the suspect test paper. So if you decide
to do the side-by-side test always do the suspect test first.
Step Three
Using the supplied dropper remove 10ml (2tsp) of the liquid from bottle
#1 and mix it with bottle #2. Shake for at least 30 seconds to mix
completely. Step
Four For the last step you must time yourself carefully.
Don't guess. Use a timer or a watch with a second hand. After the
blotting paper has dried shake bottle #2 again and using the dropper
extract a small amount of the mixed fluid form the bottle. Place a small
amount of the liquid onto the suspect blotting paper. (1-3 drops) If you
are doing a side-by-side test place a small amount of the fluid onto the
known sample at the same time.
As soon as you place the liquid onto the paper start looking at your
watch. If semen is present you will see purple color START to appear on
the paper almost immediately. If semen is present you will see this
start to happen within 15 seconds or less. If the purple color does not
appear within 5 seconds it is not a positive test and no traces of semen
are present. Any red, yellow or even slightly purple coloring that
appears after an extended time is definitely not a positive test result.
No traces of the test will be left behind on the material being
tested. If you are not concerned with staining the material and it is a
light color like white, you can place the fluid mixture directly onto
the suspected test area. The same procedure should be followed as to the
timing part of the test. If semen is present even in the smallest trace
amounts you will see the purple color appear within 15 seconds. |
