OrAlert 6-Drug Device - COC/AMPH/MAMP/THC/OPI/PCP TMS Labs OrAlert 6-panel COC/AMPH/MAMP/THC/OPI/PCP drug cassette with collector is easy-to-use, very accurate, extremely inexpensive, and tests for cocaine, amphetamine, methamphetamine, marijuana, opiate, and phencyclidine drug use.

Product Home Page Features & Benefits Symptoms & Conditions FAQs Instructions Procedure Card Performance Characteristics Product Information Principle Product Summary Other Drug Use Tests Test Medical Symptoms Home Page $15.48/test 1 test2 tests3 tests4 tests5 tests6 tests7 tests8 tests9 tests10 tests11 tests12 tests13 tests14 tests15 tests16 tests17 tests18 tests19 tests20 tests30 tests40 tests50 tests60 tests70 testsCALL US

Instructions

Allow the test device, specimen, and/or controls to reach room temperature (15-30^°C) prior to testing.

1. Bring the pouch to room temperature before opening it. Remove the test from the sealed pouch and use it as soon as possible.

2. Remove the collector from the sealed pouch and insert the sponge end of the collector into the mouth. Actively swab the inside of the mouth and tongue to collect oral fluid for a total of 3 minutes until the sponge becomes fully saturated. Gentle pressing the sponge between the tongue and teeth will assist saturation. No hard spots should be felt on the sponge when saturated.

3. Remove the collector from the mouth. Place saturated oral fluid collector into chamber and press sponge fully against the strainer to collect oral fluid. Discard the collector. Snap the cap shut on the collection chamber.

4. Place the test device on a clean and level surface. Unscrew cap cover from the collection chamber. Invert the collection chamber and transfer 3 drops of oral fluid (approximately 100 µL) into each specimen well of the test device and start the timer. Avoid trapping air bubbles in the specimen well. Place screw cap on the collection chamber. See illustration below.

5. Wait for the colored line(s) to appear. Read results at 10 minutes. Do not read results after 1 hour.

6. Apply the security seal over screw cap and send to the laboratory for confirmation if necessary.

(Please refer to the previous illustration)

NEGATIVE:* Two lines appear. One red line should be in the control region (C), and another apparent red or pink line adjacent should be in the test region (Drug/T). This negative result indicates that the drug concentration is below the detectable level.

*NOTE: The shade of red in the test line region (Drug/T) will vary, but it should be considered negative whenever there is even a faint pink line.

POSITIVE: One red line appears in the control region (C). No line appears in the test region (Drug/T). This positive result indicates that the drug concentration is above the detectable level.

INVALID: Control line fails to appear. Insufficient specimen volume or incorrect procedural techniques are the most likely reasons for control line failure. Review the procedure and repeat the test using a new test panel. If the problem persists, discontinue using the lot immediately and contact the manufacturer.

A procedural control is included in the test. A red line appearing in the control region (C) is considered an internal procedural control. It confirms sufficient specimen volume, adequate membrane wicking and correct procedural technique.

 Click here for Drug Testing Supplies such as test cups, transport vials, adulteration tests, and latex gloves and masks.

Click here for a book on how to treat teens with drug use problems.

*   Same day and next day shipments are normally the case with the exception of any out-of-stock items.
** Lifetime member discounts are subject to member terms & conditions. Also, use of this site & products sales that result from this site are subject to our  company's policies & disclaimers